ANS Việt Nam là công ty XNK hàng đầu và là nhà cung cấp chuyên nghiệp các mặt hàng “Máy móc và các thiết bị, dụng cụ đo lường, kiểm tra công nghiệp/điện-tự động hóa”
Hãy cung cấp thông tin về bất cứ sản phẩm bạn đang cần, chúng tôi bảo đảm về chất lượng, dịch vụ và giá cả tổt nhất.
Hãy liên hệ với chúng tôi để có giá tốt nhất.
0938.214.498 / 0986.025.980 |Mr Cảnh|
Công ty chúng tôi là đại diện phân phối của hãng Santerno các sản phẩm sau:
AC/DC digital converters, two quadrant DCREG2, four quadrant DCREG4
- Power range 10A - 4500A (2,4kW - 3200kW)
- Wide power supply voltage range, 200Vac - 690Vac (1000 Vac)
- Input frequency 50 - 60Hz
- Full digital
- Full compatibility with teleservice software “REMOTE DRIVE” on internet
The Thyristor converters DCREG series now offers the possibility to manage highly inductive loads such as electromagnets.
The load’s typology, assimilable to an ohmic resistor placed in series to a very high inductance, creates some applicative problems which have been efficaciously solved inside the DCREG by means of a control algorithm especially developed for this aim. The fact that the load has a high inductance level causes some functional safety problems which show themselves when, for failures or critical installation, an interruption on one of the main supply meshes is possible. Such interruption, along with the high inductive level of the magnet, can provoke strong sudden overvoltages which may even reach some thousands of Volts. It is not anyway possible to protect the converter against such overvoltages, except if you take specifi c measures while installing it. The most effi cacious method consists in providing a closing mesh on the magnet’s current, thanks to a special system called CU400.
The energy accumulated into the magnet is “absorbed” and stocked into a clamping circuit of RC type, in which the function of overcurrent limiting is ensured by the inner capacitor, while the subsequent dissipation of such energy is ensured by the inner resistor. If a power supply conducting mesh is physically interrupted (because of wiping contacts or other) or the connecting cables between magnet and converter open, the voltage arc generated by the current interruption is limited by the clamping circuit able to limit overvoltage, taking it to safe values. For this reason, the above confi guration is necessary in case of electromagnets installed on bridge cranes on which the 3phase power supply comes the main supply by means of wiping brushes which might occasionally open.
Half-controlled AC/DC single-phase drive
Half-controlled AC/DC single-phase drive used to supply armature and field circuits of D.C. motors, with analog circuit for speed or torque control.
Supply mains: 230/400VAC single-phase, through voltage setting jumper, 50/60Hz through selection jumper (dip-switch). 415/440VAC voltage values on demand.
Field supply: Single-phase rectifier bridge with suppression varistor.
Armature voltage: 0…280VDC (for 400VAC mains).
Mains insulation: Galvanic type, with tacho generator feedback.
Reference supplies: Stabilized, with values ranging from +10VDC to –10VDC.
Chúng tôi rất mong được hợp tác thành công và vui vẻ với Quý khách!
Võ Hồng Cảnh |Canh Mr|
I Sales Eng . I
I cellphone I +84 986025980
I email I firstname.lastname@example.org