Cảm Biến Vị Trí Gbf0210Mu051A0 Mts-Sensors, Mts-Sensors-Position Sensors-Gbf0210Mu051A0

Liên hệ

Hcm

Temposonics®

Absolute, Non-Contact Position Sensors

G-Series Analogue Temposonics GB Measuring length 50 - 2000 mm

• Linear, Absolute Measurement in Hydraulic Cylinders

• Contactless Sensing with Highest Durability

• Rugged Industrial Sensor, EMC shielded and CE certified

• Superior Accuracy: Linearity Tolerance better 0,02 %

• Repeatability 0,001 %

• Direct Analogue Displacement Output (V/mA)

• Measuring Range 50 bis 2000 mm

Temposonics-GB

High Pressure Rod

Measuring Range 50 - 2000 mm

These compact stainless steel position sensors are designed for installation into hydraulic cylinders, specifically for use with clevis head cylinders or any space limited cylinder applications. The GB-version sensors are ideal choices for a wide range of standard hydraulic cylinders. Magetostrictive displacement sensors, high quality cylinders and precise control valves form ideal drive systems for technically demanding machine industries. Temposonics-GB sensors provide analogue output of Voltage and Current, forward/reverse acting. The analogue output signal is proportional to the magnet position along the active measuring stroke of the sensor. The measuring range is factory

set and does not need recalibration. Since the outputs are direct, no signal-conditioning electronics are needed when interfacing with controllers or meters. Simple mechanics The extremely rugged sensor consists of 3 parts 1. The sensor head, a robust housing with built-in electronics. 2. The pressure-proof sensor pipe (up to 530 bar) with fittingflange protects the internal sensing element, the waveguide system. It fits into the bored piston rod. 3. The position magnet, the only moving part is mounted on the piston bottom. This permanent magnet travels wearfree and contactless along the stationary sensor tube. Its magnetic field starts the measurement signal through sensor’s rod wall.

Any fitiing position Simple mounting Small installation dimensions

The sensor’s high-pressure, stainless steel tube with fitting flange will be fixed via 6 machine screws M6 x 16 x A2-70 (ISO 4762) through the bores in the sensor head. The hydraulic sealing requires the use of a supplied O-Ring 15 x 2. Using ferromagnetic supports, note that the magnet must be mounted with non-ferrous spacer and screws. Position magnet

For accurate position measurements mount the magnet with non-ferrous fastening material (screws, supports ect.). Using ferromagnetic supports, note that the magnet must be mounted with non-ferrous spacer of 5 mm minimum and screws. Note the minimum mounting dimensions as illustrated right.

Cylinder installation

Use a rod bush (e. g. teflon) to prevent wear on the magnet and the sensor pipe. The bore in the piston rod is dependent on hydraulic pressure and piston velocity ect. The minimum drilling must be 13 mm. Do not exceed the 700 bar peak pressure

 

Liên hệ: Nguyễn Chí Hải

Sdt: 0398991575

Gmail: hai@ansgroup.asia

Bình luận

HẾT HẠN

0398 991 575
Mã số : 16049054
Địa điểm : Toàn quốc
Hình thức : Cần bán
Tình trạng : Hàng mới
Hết hạn : 05/09/2020
Loại tin :

Thường

Để mua hàng an toàn trên Rao vặt, quý khách vui lòng không thực hiện thanh toán trước cho người đăng tin!

Gợi ý cho bạn